Fill, shape, and finish dents to primer-ready: a gallon of High Teck 77062 lightweight filler with cream hardener, 4820 Ultra-Glaze for pinholes and low spots, a rigid PSA block with an 80-grit roll for shaping, and 180/320 discs for finishing.
What's in the kit
- 1 x High Teck 77062 lightweight body filler, gallon (cream hardener included)
- 1 x High Teck 4820 Ultra-Glaze finishing putty, 30 oz (hardener tube included)
- 3 x GL 1204 plastic spreader 4in x 3in
- 1 x High Teck AFR80 2-3/4in x 25 yd PSA sanding roll, 80 grit
- 1 x Motor Guard BGR12-1 rigid PSA sanding block, 11in
- 1 x 3M Cubitron II 31374 180+ 6in Hookit disc, 15ct
- 1 x 3M Cubitron II 31483 320+ 6in Hookit disc, 15ct
- 1 x High Teck 7800 wax & grease remover, quart
How to use it
- Clean with 7800 Wax & Grease Remover and sand the dent to bare metal, feathering 2–3" past the damage.
- Mix 77062 with its cream hardener per the label and apply with the spreaders.
- Shape with the 80-grit PSA roll on the BGR12-1 block, working in an X pattern.
- Skim pinholes and low spots with 4820 Ultra-Glaze (up to 1/8" deep), then finish with 180+, then 320+ discs.
- Clean with 7800. The area is now ready for primer-surfacer.
Not included: Mixing board, DA sander and H&L backing pad, primer, respirator and gloves.
Always follow the technical and safety data sheets for each product and use proper PPE.
















