The full-vehicle version of our bare-metal kit: a gallon of OMNI MP170 epoxy with catalyst, a gallon of OMNI MP282 high-build primer-surfacer with hardener, 30-count Cubitron II discs in three grits, and a gallon of wax & grease remover.
What's in the kit
Your choice of primer-surfacer hardener (select an option):
- MH283 – Normal Speed: 1 x MP282 2K primer-surfacer (gal) + MH283 normal hardener (qt)
- MH284 – High Temp: 1 x MP282 2K primer-surfacer (gal) + MH284 high-temp hardener (qt)
Plus:
- 1 x MP170 gray epoxy primer (gal) + MP175 catalyst (2 qt) kit
- 1 x 3M Cubitron II 31371 80+ 6in Hookit disc, 30ct
- 1 x 3M Cubitron II 31374 180+ 6in Hookit disc, 30ct
- 1 x 3M Cubitron II 31483 320+ 6in Hookit disc, 30ct
- 1 x High Teck 7800 wax & grease remover, gallon
- 3 x Scotch-Brite 64926 maroon hand pad
- 3 x Crystal PREM-A tack cloth
- 6 x PPG DOX 251 32 oz mixing cup
- 1 x PPG DOX 273 85 oz mixing cup
- 2 x Sticks & Strainers pack (5 sticks + 5 strainers)
How to use it
- Clean with 7800 Wax & Grease Remover. Strip rust and old paint to clean metal with the 80+ discs.
- Feather edges with 180+, then 320+. Scuff remaining paint with the maroon pads. Clean again with 7800.
- Epoxy: mix 2 parts MP170: 1 part MP175, strain, and apply over bare metal.
- Primer-surfacer: within the recoat window on the MP17x TDS, mix 4 parts MP282: 1 part hardener and apply 2–3 coats.
- Once cured, block MP282 (wet P400 then P600, or dry P360 then P500, per PPG). Choose MH283 Normal for typical shop temperatures or MH284 for high temperatures.
Not included: DA sander and H&L backing pad, spray gun, respirator, gloves, guide coat, and P360–P600 finish paper.
Always follow the technical and safety data sheets for each product and use proper PPE.
















