Take a rusted or bare-metal panel from sanding to primer-ready: Cubitron II discs to strip and feather, OMNI MP170 epoxy to seal bare steel against corrosion, and OMNI MP282 high-build primer-surfacer to fill sanding scratches.
What's in the kit
Your choice of primer-surfacer hardener (select an option):
- MH283 – Normal Speed: 1 x MP282 2K primer-surfacer (qt) + MH283 normal hardener (1/2 pt)
- MH284 – High Temp: 1 x MP282 2K primer-surfacer (qt) + MH284 high-temp hardener (1/2 pt)
Plus:
- 1 x MP170 gray epoxy primer (qt) + MP175 catalyst (pt) kit
- 1 x 3M Cubitron II 31371 80+ 6in Hookit disc, 15ct
- 1 x 3M Cubitron II 31374 180+ 6in Hookit disc, 15ct
- 1 x 3M Cubitron II 31483 320+ 6in Hookit disc, 15ct
- 1 x High Teck 7800 wax & grease remover, quart
- 2 x Scotch-Brite 64926 maroon hand pad
- 2 x Crystal PREM-A tack cloth
- 2 x PPG DOX 249 8 oz mixing cup
- 2 x PPG DOX 251 32 oz mixing cup
- 1 x Sticks & Strainers pack (5 sticks + 5 strainers)
How to use it
- Clean with 7800 Wax & Grease Remover. Strip rust and old paint to clean metal with the 80+ discs.
- Feather the edges with 180+, then 320+ discs. Scuff surrounding paint with the maroon pads. Clean again with 7800.
- Epoxy: mix 2 parts MP170: 1 part MP175 in the cups, strain, and apply over bare metal.
- Primer-surfacer: within the recoat window on the MP17x TDS, mix 4 parts MP282: 1 part hardener and apply 2–3 coats.
- Once cured, block MP282 (wet P400 then P600, or dry P360 then P500, per PPG) before topcoat. Choose MH283 Normal for typical shop temperatures or MH284 for high temperatures.
Not included: DA sander and H&L backing pad (discs are 6" Hookit), spray gun, respirator, gloves, and P360–P600 finish paper.
Always follow the technical and safety data sheets for each product and use proper PPE.
















